How To Change IP address

Here Below Steps To Change IP Address Of Your Computer With CMD.

No Need Any Softwares.

Step 1. Click on "Start" in the bottom left hand corner of screen

Step 2. Click on "Run"

Step 3. Type in "cmd" and hit ok You should now be at an MSDOS prompt screen.

Step 4. Type "ipconfig /release" just like that, and hit "enter"

Step 5. Type "exit" and leave the prompt

Step 6. Right-click on "Network Places" or "My Network Places" on your
desktop.

Step 7. Click on "properties

You should now be on a screen with something titled "Local Area
Connection", or something close to that, and, if you
have a network hooked up, all of your other networks.

Step 8. Right click on "Local Area Connection" and click "properties"

Step 9. Double-click on the "Internet Protocol (TCP/IP)" from the list
under the "General" tab

Step 10. Click on "Use the following IP address" under the "General" tab

Step 11. Create an IP address (It doesn't matter what it is. I just
type 1 and 2 until i fill the area up).

Step 12. Press "Tab" and it should automatically fill in the "Subnet
Mask" section with default numbers.

Step 13. Hit the "Ok" button here

Step 14. Hit the "Ok" button again You should now be back to the
"Local Area Connection" screen.

Step 15. Right-click back on "Local Area Connection" and go to
properties again.

Step 16. Go back to the "TCP/IP" settings

Step 17. This time, select "Obtain an IP address automatically" tongue.gif

Step 18. Hit "Ok"

Step 19. Hit "Ok" again

Step 20. You now have a new IP address

With a little practice, you can easily get this process down to 15 seconds.